MRF EezeeWood Interior Glossy 200ml

MRF EezeeWood is an economical, single pack polyurethane clear wood finish for interior woods. MRF EezeeWood Exterior Matt gives a luxurious gloss finish to the wooden surface. It can be applied on interior wooden surfaces. It can be applied on surfaces that under go daily wear such as table tops and entrance doors. The coating provides long lasting protection to interior woods.

Features

• Resistant to scratches
• Water resistant
• Easy to apply using a brush or roller

Application

Surface Preparation

• The raw wooden surface to be coated should be clean, dry, free from moisture ,dampness and other contamination
• For hard wood, sand the surface using Sandpaper #80, followed by Sandpapers #120, #150, #180 and #220
• For Veneer ply surfaces,start with Sandpaper #220
• Always sand in the direction of the wood grain

Application Procedure

• Mix the material thoroughly prior to application.
• Avoid applying in direct sunlight or when the humidity is very high
• Apply 2 to 3 coats of EEZEEWOOD XT / Interior Sealer clear with an interval of 12 - 16 hours between the subsequent coats. Sanding should be done prior to the application of each coat. Sandpaper #220 can be used for the first coat and Sandpaper #400 can be used for the second and third coats
• The number of coats of sealer required varies from 2 to 3 depending on the absorption of wood
• Apply 2 coats of either EEZEEWOOD XT / Interior Glossy Clear or Matt Clear depending on the requirement, with an interval of 12 - 16 hours between the subsequent coats. Sanding of the 1st coat of top coat shall be done with #600 or #1000 Sandpaper
• MRF Woodstains Interior shades can be used to enhance the colour of the wood grain. The available shades can be used over either the first coat or the second coat of sealer clear sanding of the applied shade is not permitted
• For Interior applications use Woodstains Interior shades only

Points to note

Use of inferior quality thinners and sealers/fillers should be avoided since it compromises the quality of the coating.

Technical Details

• Thinner Recommended - Thinner 3834
• Drying and recoating Time : 6-8 hours
• Coverage : 70 - 80 sqft per coat. Subsequent coats will have up to 15% higher coverage.
• Finish : Transparent, Glossy