Asian Paints Apcolite Satin Enamel Base White SE2 10L

Apcolite Satin Enamel Base White SE2 can be brushed, rolled or sprayed onto metal and wood surfaces. 

Features

• Brush, Roll, Spray
• Good finish
• Available in Satin & Gloss Finishes
• Wide range of attractive shades

Downloadable Resources

Application Procedure

Surface Preparation

• For Metal : Ensure that the surface is dry, clean and free from impurities like oil, grease, loose rust and cracked or flaked paint. Sand the surface with #180 sand paper and ensure no loose particles are present before priming. Wipe the surface Clean.
• For Wood : The raw wooden surface to be coated should be clean, dry, free from moisture, dampness and other contamination. Sand the surface using #80 sand paper, followed by grit sizes #120, #150, #180 and #220 sand paper. This step wise approach leads to a very smooth surface. Always sand in the direction of the grain. This step wise process is applicable for hard wood. Start with #220 sand paper for veneer or plywood.

Application

For Metal

• Shake can thoroughly before opening. Ensure paint is mixed well before thinning.
• Apply 2 Coats of Asian Paints Yellow Metal Primer (with recommended thinning with mineral turpentine) by brush or spray with an interval of 4-6 hours between coats.
• The primed surface can be sanded using #220 sand paper after 10-12 hours of drying.
• Appropriate filler to be used for filling dents and imperfections which should then be sanded and primed again.
• Apply 2 coats of Apcolite Stain shade diluted with 15-20% by volume of mineral turpentine with an interval of 6-7 hours by brush or spray.

For Wood

• Apply 2 to 3 coats of Wood Primer with an interval of 5-6 hours between subsequent coats.
• Sanding should be done prior to application of Topcoat.
• #400 sand paper can be used for sanding after 10-12 hours of drying.
• Apply 2 coats of Apcolite Stain shade with an interval of 6-7 hours by brush or spray.

Technical Specifications

• Thinner Recommended - Mineral Turpentine
• Thinner Intake - 15-20% for Brushing, 30-35% for Spraying
• Coverage - 100 sqft per litre per coat