Asian Paints SmartCare Crack Seal 360g

Asian Paints SmartCare Crack Seal is a ready to use fiber glass reinforced crack filling compound for both interior and exterior surfaces. It ensures unmatched crack bridging ability for plaster cracks of up to 3 mm.

Features

• Crack filling ability Strong filling capacity for cracks of up to 3mm width.
• Flexibility High elongation polymer that accommodates movement.
• Mechanical strength Reinforced with glass fibers for superior mechanical strength.
• Waterproofing Water resistant film stops water ingress through cracks.
• Adhesion Very strong adhesion on all absorbent surfaces like plaster, wood, gypsum, POP, asbestos, etc.
• Usage Single pack ready-to-use and easy-to-apply product.
• Over coating Easily over coated by emulsion paints.

Recommended Usage

• For cracks in plaster upto 3mm wide on interior and exterior absorbent surfaces. Ideal for cracks caused by shrinkage and drying.
• Not recommended for filling gaps and cracks in construction joints.

Application

Application Video

Application Description

Surface Preparation

• Cleaning and Opening Cracks Open and widen the cracks in a 'V' shaped groove. This will provide a strong base for adhesion of Crack Seal to the surface. Wire brush and clean the area throughly with water to free it from dust and loose particles. Any algal/fungal growth must be cleaned using a bio-wash such as bleaching powder.
• Priming Dilute Crack Seal with water to get a paint consistency. Apply using a flat brush into the crack. Any water based primers can also be used for the purpose of priming. Allow to dry.

Application Procedure

• First Coat Using a putty knife, press Crack Seal into the crack in a direction perpendicular to the crack. Remove excess material by moving the putty knife along the crack. Allow to dry for 4-6 hours.
• Second Coat Apply a second coat using the same procedure as above. Allow to dry for 4-6 hours.
• Level the surface using the recommended putty.
• Continue priming and painting as normal.

Quick Tips

• Use Crack Seal only for plaster cracks and not to fill construction joints.
• Crack Seal can be tinted to light shades to get better hiding when over coated.
• Do not apply on wet surfaces. The surface should be saturated with water but should not have running or standing water.

Tech Specs

• Form Ready to use paste
• Density at 25deg 1.28
• Drying Time Min 6 hours, depending on temperature and humidity
• Flash Point Water based and non flammable
• Consumption 75-80 running feet /kg /2 coats (cracks 3mm wide and 5mm deep)

Safety Information

• Kindly refer to the MSDS for Asian Paints SmartCare Crack Seal gives detailed information on safety measures while handling the paint, which is available on request.
• Store the container with the lid tightly closed in an upright position, in a cool, dry place
• Keep out of reach of children and away from eatables.
• May be harmful if swallowed. In case of ingestion seek immediate medical attention.
• Wear eye protection during application. In case of contact with eyes, rinse immediately withplenty of water and seek medical advice.
• In case of skin contact immediately wash skin with soap and plenty of water. Get medicalattention if irritation develops or persists.
• Do not breathe vapour or spray.It is recommended to wear suitable nose pad during sanding and surface preparation to avoid dust inhalation.
• Do not pour leftover paint down the drain or in water courses.
• In the event of spills, contain spillage using sand or earth.
• No added Lead, Mercury or Chromium compounds.