Ardex Endura Heavy Duty Impregnating Tile & Stone Sealer 1L

Heavy Duty Impregnating Tile & Stone Sealer is a solvent based deep penetrating sealer designed for use on marble, lime stone, granite, slate, terrazzo and other natural stone to reduce the water permeability of the surface. It reduces stains, seals with a wet look finish enhancing the colour of the stones and provides a breathable surface.

Features

• Seals with a wet look finish
• Stain resistant
• Non-yellowing
• Improves wear resistant of surface
• Reduces water permeability
• Enhances the colour of the stone
• Suitable for both exterior and interior applications

Coverage

Approximately 5 to 15 m²/litre/coat depending on porosity

Areas of Application

• Heavy Duty Impregnating Tile & Stone Sealer is designed for use on marble, lime stone, granite, slate, terrazzo and other natural stone.
• Can be used to seal porous substrates such as concrete and cement plaster.

Method of Application

• Test the Sealer initially on a small inconspicuous area.
• Ensure the surface is clean.
• Use suitable cleaner to remove any cementitious deposits.Following cleaning, thoroughly rinse with clean water and allow the area to completely dry out for approx. 3 days.
• Apply Heavy Duty Impregnating Tile & Stone Sealer to the surface using a soft bristle brush or a fluff free cloth and leave it to soak for approx. 5 minutes.
• Wipe off any surplus sealer remaining on the surface.
• Two or more coats as necessary depending on the porosity.
• Allow 2 hours of drying time between coats.
• The floor can be trafficked 24 hours after the final coat depending on the condition.

Note :Always allow adequate ventilation when using.

Limitations

• Do not use the sealer in damp condition as it may form white patches and come out as flakes.
• Do not keep the container open for a long time.