Tenax ProSeal - Oil and Water Repellant Stone Sealer 1L

Tenax ProSeal is a solvent based sealer for sealing natural stone to make the stone water and oil repellant. This product can be used to seal natural stone and also epoxy treated polished stone and granite.

The product can be used on a variety of natural stones such as :

• Granite (including the exotic granites)
• Limestone
• Sandstone
• Terrazzo
• Concrete agglomerate
• and even Engineered stone.

Tenax ProSeal is also known to work very well on porous substrates such as concrete.

Features

• Makes Stone Oil and Water resistant.
• Does not change the look of the stone.
• Can be applied even on polished stone and granite.

Application

• The product must be evenly applied on dry and clean surfaces.
• Spread the product using a brush, sponge, cloth or through a spray gun. Use the right quantity that the stone can naturally absorb.
• Then, after few seconds, clean (buff) the surface using a clean and dry rag. The excess may create a superficial sticky film, so it must be removed immediately after the application.
• We suggest to repeat this treatment after 10-15 minutes from the first application.
• In case of floor application, do not walk on the surface before 24 hours.
• The effect of anti stain will be achieved after 24 hours from the treatment.

Refer to the video below for the application procedure :

Technical Specifications

• Coverage 200 - 300 sqft per liter depending upon whether the stone is raw or polished. Coverage will be better on polished stones.
• Health hazard Do not inhale fumes, use a mask. Use eye protection.